[Amazon.ca] Dewalt 2pc 10” 60 Tooth fine cutting saw blade $54.79

Link:: https://www.amazon.ca/gp/aw/d/B00005A1H … &psc=1
Price:: $54.79
Discount:: 38%
Retailer:: Amazon.ca

Was searching for a 10” blade for my miter saw and discovered this two pc on amazon. Everywhere else seemed to have one blade around $50. Looks like a hot deal but I’m not always shopping for blades so you be the judge.

Amazon product: DEWALT DW3106P5 2 Blade 10-Inch 60-Tooth Crosscutting Saw Blade and 10-Inch 32-Tooth General Purpose Saw Blade Combo Pack
Customer Reviews:
This two blade pack is a great deal – I’ve used the 60-tooth one to replace the factory blade in my 10″ miter saw, and the 32-tooth one in my table saw. The 40-teeth factory blade I replaced in the miter saw wasn’t bad, but this Dewalt one does cut easier and much cleaner. | Same for the table saw, I replaced a 24-tooth blade with this 32 tooth one, and cuts are a good deal cleaner as you’d expect. These Dewalt blades are a definite upgrade over the stock blades I replaced, so I’m very happy with them. | Just to quickly try the blades out I cross-cut some scrap 4×2 with the miter saw and got much sharper, cleaner cuts than the blade I replaced, and ripped through some scrap 3/4″ ply on the table saw and the 32 tooth blade goes through it cleanly and quickly, like a hot knife through butter. | Note: The blades I received are slightly different than the Amazon product picture (model number is correct, just picture is different) – they don’t have the yellow painted saw teeth. Not sure if there’s any real material difference but time will tell – hopefully these silver teeth ones are not some new cheapo version! So far from my limited test run they’re fine for my hobby woodworking needs! 🙂 | If you do get the yellow coated teeth version, bear in mind they might seem a bit ‘dull’ cutting to start with so make a few cuts in some scrap to wear the finish off a bit – the dullness is just the coating, so don’t worry that these are not sharp. They are – very! | Also don’t forget that the yellow paint will wear off on the wood you cut – so again, make a few cuts in some scrap first to just wear it off a bit.

Image: